Skip to content
Lambeth Lock & Key Co.Request a visit
Open 24/7(226) 785-2980Call now
Technician inspecting splintered wood around a door-frame strike plate. — Break-In Damage Lock Repair, London

Emergency Lockouts · London

Break-In Damage Lock Repair in London

The shop's aluminum door has a bent meeting stile and the hookbolt is jammed half out. The alarm did its job and the display is untouched, but the entrance will not close properly and opening time is hours away.

Call now · open 24/7(226) 785-2980

Request a visit

In plain words

When a home is broken into, the locks are not the only thing that has changed hands. Keys hanging in the hall, a spare in a drawer, a garage remote on a visor or a house key on a stolen car's ring may all be gone. Part of break-in damage repair is closing that door too. Every cylinder those keys fit is rekeyed or replaced and fresh keys are cut, the mailbox and padlocks are considered, and you are reminded to reset the garage opener and any alarm codes that were written down. The forced door gets fixed, and the missing keys stop mattering at the same time.

Sound familiar?

The patio slider is sitting crooked on its track. Its latch is snapped, the frame is bowed where it was pried, and the panel no longer meets the jamb, so the house cannot be closed up for the night.

How the visit goes

Break-In Damage Lock Repair · London

How the visit goes

Technician in a cap and glasses holding a small key fob beside the dashboard of a black motorcycle in a garage. — London
  1. 1

    Does the door still hang true

    An impact hard enough to break a strike usually moves the door as well. The locksmith checks that the door sits square in its opening, closes on its weatherstrip without force, and that the bolt lines up with its pocket rather than dragging on the strike lip. Hinge screws are tested for grip, since a kick can pull them from the jamb even on the side that was not attacked, and the hinge leaves are checked for bending. Manufacturers treat strike position, pocket depth and door alignment as working parts of the lock, and a repair that ignores them produces a door that locks badly the day after it was fixed.

  2. 2

    Storefront and commercial doors

    Aluminum storefront doors fail differently: the narrow stile bends under a pry bar, the hookbolt or deadlatch is forced, or the glass is broken. The locksmith straightens or replaces the stile section where possible, fits a new narrow-stile deadbolt or hookbolt with a matching strike, and adds a latch guard plate or an anti-pry astragal along the meeting edge so a bar has nothing to grip. Interchangeable cores are rekeyed and access codes reviewed with the owner. Where the door is part of an exit route, the inside hardware is kept as a single-motion release so the repair strengthens the entrance without changing how people leave.

  3. 3

    Glass and the reach-in problem

    When entry came through glass beside the door, the lock was never the weakness, and the follow-up is about the glass. A tested security-film system, applied with its specified frame attachment, can slow an arm from passing through the sidelight, or the pane is replaced with laminated glass by a glazier. Where the layout allows, the deadbolt is repositioned beyond arm's reach of the glass. A thumb-turn stays on the inside, because it lets everyone leave without hunting for a key, and a keyed inside cylinder trades one risk for a worse one if there is ever a fire. The result keeps the intruder out and the way out clear.

In the van

  • Jamb repair plate
  • Two-part wood epoxy and shims
  • Anti-lift blocks and foot bolt
  • Security strike box
  • Three-inch strike and hinge screws

What affects the quote

  1. 1

    Work referred to another trade

    A shattered frame, a broken door slab or smashed glass is listed as needing a carpenter, door installer or glazier, and that work is quoted by those trades rather than by the locksmith.

  2. 2

    Securing now versus repairing fully

    Some households want the door locked tonight and the permanent repair booked later; others want both done at once. The quote separates the two so you can choose either order without surprises.

  3. 3

    Door edge reinforcement

    A wrap-around edge reinforcer is added when the wood around the bore is crushed or split. It is a separate part, chosen to suit the door thickness and the hardware going into it.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(226) 785-2980

Break-In Damage Lock Repair: questions

Advice · (226) 785-2980

Can a split jamb be repaired, or does it need replacing?

Many can be repaired. A split along the grain is pressed back together, glued with a two-part wood epoxy and held by a steel repair plate or a boxed strike screwed through it into the stud, so the fasteners reinforce the repair as well as the lock. Missing wood is built up with filler or a fitted piece. A jamb that has pulled off the framing along its length or shattered around the pocket is replaced by a carpenter, with the opening secured until then.

Is the lock that was forced still usable?

Sometimes, and the locksmith tests it honestly. A deadbolt that stayed thrown while the frame gave way may be undamaged, though a kick can bend the bolt where it crossed the gap or crack the housing. A cylinder that was twisted, drilled or punched is finished. Reused hardware must operate as smoothly as new with the door open and closed; if it hesitates, it is replaced, because a lock that took a blow tends to fail at the worst moment.

What should I have ready when I call about a break-in?

Whether the police have been called and any occurrence number; whether everyone is safe and the property is empty of intruders; which opening was forced and whether it closes at all; whether the damage is to the lock, the frame, the door or the glass; whether keys, remotes or codes were taken; whether you own, rent or manage the property; and whether there is glass beside the door. Photos on your phone help the locksmith bring the right hardware.

Break-In Damage Lock Repair near you

Middlesex, Ontario

London information

Town
London, Middlesex, Ontario
In business
15 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

52%

Older homes. About 52% of homes in London were built in 1980 or earlier, according to the 2021 Census.

Layers of paint build up on older doors and frames, and a lock that seemed to fail is sometimes a latch glued shut by the last coat. Part of the visit in an older area is freeing hardware, cleaning the edges and checking the door swings true.

49%

A mix of homes. Single-detached houses make up about 49% of homes in London (2021 Census).

In mixed neighbourhoods, a family may move from an apartment to a house or the other way around. A locksmith who knows both kinds of door can rekey the old place for the next occupant and set up the new one on the same visit.

Source: Statistics Canada, 2021 Census of Population

Open London in Google Maps

Open 24/7

Request a visit

The shop's aluminum door has a bent meeting stile and the hookbolt is jammed half out.

Call now · open 24/7(226) 785-2980
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 15 years in business